Arduino 144Pixels 5050 Rgb Led Strip Light Waterproof IP65

Arduino 144Pixels 5050 Rgb Led Strip Light Waterproof IP65
Product parameter
LED Chip SMD5050 RGB LED chip
IC Chip APA102C IC built-in
LED Quantity 144LEDs/m
Input Voltage DC5V
Watts 34.56W/M
IP Rate IP20(non-waterproof), IP65(Silicon-tube waterproof)
PCB Color White PCB, Black PCB
View Angle 120°
Standard Reel Length 1meter/roll, also can be customized
PCB Width 12mm
Operating Temperature -20 ~ +40°C
Storage Temperature -40 ~ +80°C
Color Addressable full color
Product Description
1. Addressable full color led strips ——APA102C IC built-in.

2. Individually control —— 1 IC & I LED chip.

3. Standard Reel Length: 5meter/roll, also can be customized.

4. Cutted: 1 integrated RGB LEDs per segment, can be cutted per 1LED.

you can cut this stuff pretty easily with wire cutters, there are cut-lines

every 0.65''/0.7cm(1 LED each), Solder to the 0.1'' copper pads and you're good to go.

5. Power supply: You must use a 5V DC power supply to power this striup,

do not use higher than 6V or you can destroy the entire strip.

6. Sticky: non-waterproof: with 3M adhesive on back side for sticky;

waterproof: screw+silicon clip, or 3M adhesive back side.

7. Connectors: 4PIN JST female and male connectors, DAT, CLK, DC5V+, GND-.

these LEDs have 2 wires (input and output) for sending data - one clock pin and one data pin. That means you need two pins, not one, to control DotStars. Because the clock and data is seperated, you can use any processor speed or type to control these strips, and you don't have to worry about being careful with the timing.

8. Type:

This is the 60 LED-per-meter version, We have 30 LED/m, 60 LED/m and 144 LED/m.

Waterproof——white PCB; Waterproof——black PCB

Non-waterproof ——white PCB; Non-waterproof——black PCB

9. LED Brightness: Red ~600mcd, Green ~500mcd, Blue ~150mcd

10. Brand: iPxel LED